# Unity Framework Configuration
CONFIG_UNITY_ENABLE_FLOAT=y
CONFIG_UNITY_ENABLE_DOUBLE=y
CONFIG_UNITY_ENABLE_64BIT=y

CONFIG_ESPTOOLPY_FLASHSIZE_4MB=y

#enable BT
CONFIG_BT_ENABLED=n
#enable lwip ipv6 autoconfig
CONFIG_LWIP_IPV6_AUTOCONFIG=y

# Use a custom partition table
CONFIG_PARTITION_TABLE_CUSTOM=y
CONFIG_PARTITION_TABLE_FILENAME="partitions.csv"
CONFIG_PARTITION_TABLE_OFFSET=0xC000

# Enable chip shell
CONFIG_ENABLE_CHIP_SHELL=y

# Disable WiFi — unit tests don't need networking and WiFi PHY calibration hangs in QEMU
CONFIG_ENABLE_WIFI_STATION=n
CONFIG_ENABLE_WIFI_AP=n
CONFIG_ESP_WIFI_SOFTAP_SUPPORT=n

# Use QEMU virtual Ethernet instead of WiFi
CONFIG_ETH_USE_OPENETH=y
CONFIG_ENABLE_ETHERNET_TELEMETRY=y

#enable lwIP route hooks
CONFIG_LWIP_HOOK_IP6_ROUTE_DEFAULT=y
CONFIG_LWIP_HOOK_ND6_GET_GW_DEFAULT=y

# This example only use 2 dynamic endpoints
CONFIG_ESP_MATTER_MAX_DYNAMIC_ENDPOINT_COUNT=16

# Enable HKDF in mbedtls
CONFIG_MBEDTLS_HKDF_C=y

# Increase LwIP IPv6 address number to 6 (MAX_FABRIC + 1)
# unique local addresses for fabrics(MAX_FABRIC), a link local address(1)
CONFIG_LWIP_IPV6_NUM_ADDRESSES=6

# borrowed from unit-test-app
CONFIG_FREERTOS_WATCHPOINT_END_OF_STACK=y
CONFIG_HEAP_POISONING_COMPREHENSIVE=y
CONFIG_SPI_FLASH_ENABLE_COUNTERS=y
CONFIG_ESP_TASK_WDT_INIT=n
CONFIG_SPI_FLASH_DANGEROUS_WRITE_FAILS=y
CONFIG_COMPILER_STACK_CHECK_MODE_STRONG=y
CONFIG_COMPILER_STACK_CHECK=y
CONFIG_ADC_DISABLE_DAC=n
CONFIG_COMPILER_WARN_WRITE_STRINGS=y
CONFIG_SPI_MASTER_IN_IRAM=y
CONFIG_EFUSE_VIRTUAL=y
CONFIG_UNITY_ENABLE_BACKTRACE_ON_FAIL=y